Kingston 16GB 1600MHz DDR3 CL11 SODIMM (Kit of 2x8GB)

SPECIFICATIONS

CL(IDD) 11 cycles

Row Cycle Time (tRCmin) 48.125ns (min.)

Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 35ns (min.)

Maximum Operating Power 2.580 W* (per module)

UL Rating 94 V - 0

Operating Temperature 0o C to 85o C

Storage Temperature -55o C to +100o C

ValueRAM's KVR16S11K2/16 is a kit of two 1G x 64-bit (8GB)

DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory

modules, based on sixteen 512M x 8-bit FBGA components per

module. Total kit capacity is 16GB. The SPDs are programmed

to JEDEC standard latency DDR3-1600 timing of 11-11-11 at

1.5V. Each 204-pin SODIMM uses gold contact fingers. The

electrical and mechanical specifications are as follows:

FEATURES

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component

http://www.kingston.com/dataSheets/KVR16S11K2_16.pdf